AEG Solo combo 15 - Manual (Page 16)

14
tPress at the bottom of the corded base to put the intercom call on hold and answer the incoming
call. Then you can press and hold to set up a conference call between all three parties, or you
can end the call on the corded handset, which will transfer the incoming call to the other intercom
handset.
9.10 Transfer an External Call from the Corded Base to a Cordless Handset
tDuring the call, press
at the bottom of the corded base to put the external call on hold.
> Intercom is established immediately with all registered cordless handsets.
Note:
If there is no answer from the cordless handset, or you wish to cancel the intercom call before it is
answered, press
at the bottom of the corded base to return to the external call.
tPress on the cordless handset to answer the internal call, where both internal callers can talk.
tReturn the corded handset to the corded base or press to transfer the external call to the cordless
handset.
9.11 Initiate a Conference Call during a Call on the Corded Base
You can establish a 3-way conference by inviting another cordless handset to join in a conference call
with you and the external caller.
tDuring the call, press
at the bottom of the corded base to put the external call on hold.
>Intercom ringing starts immediately with all registered cordless handsets.
Note:
If there is no answer from the cordless handset, or you wish to cancel the intercom call before it is
answered, press
at the bottom of the corded base to return to the external call.
tPress on the cordless handset to answer the internal call, where both internal callers can talk.
tWhen the intercom call is connected, press and hold
at the bottom of the corded base for 2 - 3
seconds to connect the call in conference mode.
9.12 Call from the Redial List
The corded base stores only the last number dialled.
tIn standby mode, press
on the corded base.
>The last number dialled is displayed.
tPress or lift up the handset from the corded base.
>The number will be dialled out automatically.
9.13 Store a pre-dial number to the Phonebook on the Corded Base
tIn standby mode, enter the pre-dial number.
tPress and hold
.
>The pre-dial number is displayed.
tPress
to save the pre-dial number into the phonebook.
>A confirmation tone is played and the corded base returns to standby mode.
9.14 Store a number from the Redial List to the Phonebook on the Corded Base
tIn standby mode, press on the corded base.
>The last number dialled is displayed.
tPress and hold
.