Xerox WorkCentre XD103f Digitaler Kopierer - Laserdrucker-10252 - Manual (Page 51)

43
Printer Driver Software Installation
1. Ensure that the computer and the
WorkCentre are turned off.
2. Plug the IEEE-1284 cable into the
parallel port on the WorkCentre.
3. Plug the other end of the IEEE-1284
cable into the computer.
4. Ensure that the power cord is plugged into the WorkCentre and then
into a grounded outlet.
• Do not attach your WorkCentre to a pass-through port of another
device (scanner, CD-ROM drive, tape drive, Zip
™
drive or external
disk).
5. Turn on the PC.
Note: Close all applications before installing the printer driver.
6. Start Windows on your computer.
7. Insert the WorkCentre XD CD-ROM into the CD-ROM Drive.
Go to step 8 of the Installation procedure for the software version
that you are running.
Installation for Windows 3.1x
(continued from step 7)
8. Choose File from the menu bar in Program Manager, and then choose
the Run… command.
9. Type D:\SETUP (or the appropriate drive letter depending on your CD-
ROM Drive) in the command line box. Click on the OK button to
proceed.
10. Follow the on-screen instructions.
11. When the install is complete, restart Windows and turn on the
WorkCentre.
Installation for Windows NT 4.0 or 95/98
(continued from step
7)
8. Click on the Start button and then choose the Run menu option.
9. Type D:\SETUP (or the appropriate drive letter depending on your CD-
ROM Drive) in the command line box. Click on the OK button to
proceed.
10. Turn on the WorkCentre.
11. Follow the on-screen instructions.
• If you wish to print a test page, ensure paper is loaded and then click
the Yes button.