Xerox WorkCentre XD103f Digitaler Kopierer - Laserdrucker-10252 - Manual (Page 32)

24
Paper Tray Bypass
(XD100/102/103f/120f/125/125f only)
Use the Paper Tray Bypass to copy onto paper that is different from that
loaded in the paper tray and to copy onto special stock such as envelopes,
labels, or transparencies. Stock is fed one sheet at a time into the Paper
Tray Bypass.
The minimum copy size is 3.5
×
5.5"/ A6. The maximum copy paper size is
8.5
Ч
14" / 216
Ч
356mm.
Load special stock as follows:
Predrilled paper: holes toward the rear of the copier.
Letterhead paper: face down with the top toward the left.
Envelopes: flap side up and toward the rear.
Labels: face down.
Transparencies: removable stripe face up and toward the rear.
• Use labels, transparencies, and envelopes specifically designed for
copiers (high temperatures).
1. Place the original face down and align
it with the registration guide on the
document glass and close the
document cover.
XD103f/120f/125f copiers only
Unless the SPF auto start has been
disabled, the paper tray bypass cannot
be selected.
2. Adjust the bypass guide to the width of
the copy paper.
3. Insert a single sheet of paper into the
paper tray bypass.
• The paper will feed automatically.
• When copying continuously, insert
the next copy paper as soon as the
previous sheet has fed.