Xerox WorkCentre XD103f Digitaler Kopierer - Laserdrucker-10252 - Manual (Page 20)

12
Power Reduction / Auto Clear
Power Reduction Modes automatically reduce power consumed by the
WorkCentre when the WorkCentre has not been used for a set period of
time. There are two modes of power reduction; Power Save, and Power
Shut-off.
Power Save Mode – The Ready Indicator will flash and the other indicators
will remain on. To copy from the Power Save mode select the desired
features and press Start. The copies will be made automatically.
Power Shut-Off Mode – When the WorkCentre enters the power shut-off
mode the Ready Indicator will flash and the other indicators will turn off. To
copy from the power shut-off mode, press the Start button, then, select the
desired features and press Start again. The copies will be made
automatically.
Auto Clear – This WorkCentre is enabled at the factory to return to the
Normal Copy Mode approximately one minute after a job is completed.
Unless otherwise programmed, the Normal copy Mode settings are as
follows:
•
Copy Quality – Auto
•
Copy Lighter/Darker – Normal
•
Priority Tray – Tray 1
•
Priority Magnification – 100%
•
Quantity Selected – 1
Note: Time periods for the Power Shut-Off, Power Save, and Auto Clear
modes can be modified to meet your specific copying needs. Refer to
Customizing Your WorkCentre section of this User Guide for information
about changing these settings.
Auto Copy Function
This function provides the ability to program a copy job while the copier is
warming up, or to pause a print job to enable copying.
1. Program the copy job.
2. Press Start.
• The current page will be completed if printing is in process.
3. When the copy job is completed, press the On-line/Off-line button to
immediately return to the print job.