Xerox WorkCentre XD103f Digitaler Kopierer - Laserdrucker-10252 - Manual (Page 37)

29
Feature Program
Number
Option Number
* Factory Setting
Default Image Quality: This feature
allows you to select the default Image
Quality mode. 5 0 – Auto Exposure *
1 – Text
2 – Photo
Auto Contrast Adjustment: The
copy contrast range may be adjusted
when the copy image is consistently
too light or too dark in the Auto Image
Quality mode. 6 0 – Lightest
1 – Lighter
2 – Normal *
3 – Darker
4 – Darkest
Paper Trail Edge Deletion: The trail
edge deletion can be turned Off to
accommodate originals that have print
to the very bottom edge. When Off,
another 4 mm will copy, however the
image quality may deteriorate as it
gets closer to the bottom edge.
When this feature is On each time the
paper tray is opened edge deletion is
disabled for the first copy. Edge
deletion is enabled for the following
copies. 7 0 – On *
1 – Off
Paper Tray Bypass Auto Start:
When enabled, the copier will begin to
copy as soon as paper is fed into the
paper tray bypass.
(Models XD100/102/103f/120f/125/125f
only.)
8 0 – On *
1 – Off
Single Pass Feeder Auto Start:
When enabled, the SPF will begin to
copy as soon as paper is placed in
the SPF.
(Models XD103f/ 105f/ 120f/ 125f only.)
9 0 – On *
1 – Off
Automatic Document Feeder Auto
Start: When enabled, the ADF will
begin to copy as soon as paper is
placed in the ADF.
(Models XD130df/155df only.)
9 0 – On
1 – Off*
Reduction/Enlargement Preset:
This feature allows you to set a
specific preset reduction or
enlargement setting for the
key.
10 50 – 200%
Default 50% *