Konica Minolta magicolor 1690MF - Manual (Page 47)

Basic Fax Operation 3-4
"
If memory is nearly full, scanning of the document is stopped and a
message appears, allowing you to select whether to start the trans-
mission or cancel that transmission job. If the selection is made to
cancel the job, the pages of the document that have been scanned for
that job are deleted. If the selection is made to begin the transmission,
transmission begins. After the scanned pages have been sent, scan-
ning of the document starts again.
Sending a Fax Using the Original Glass
1
Press the Fax key to enter Fax mode.
"
If the initial mode (UTILITY - MACHINE SETTING - INITIAL MODE)
is set to FAX, this step can be skipped.
2
Remove all documents from the ADF.
"
If you are using the original glass to scan, do not load any documents
into the ADF.
3
Lift to open the ADF cover.
4
Place the original document face down on the original glass and align the
document on the scales above and to the left of the original glass.
5
Gently close the ADF cover.
"
Closing it too quickly may cause the document to move on the original
glass.
6
Adjust the document image quality.
"
For details on adjusting the document image quality, refer to “Adjust-
ing the Image Quality” on page 3-6.
7
Specify the fax number of the recipient in one of the following ways:
– Direct dialing
– Using the favorite list
– Using the Speed Dial function
– Using the Group Dial function
– Using the Phone Book functions
– Using the Redial/Pause key
"
For details on specifying the recipient, refer to “Specifying a Recipient”
on page 3-7. For details on using the Redial/Pause key, refer to
“Using the Redial Function” on page 3-11.