Konica Minolta bizhub 40P - Manual (Page 98)

Media Types 88
Use envelopes that are
„ Common office envelopes approved for laser printing with diagonal joints,
sharp folds and edges, and ordinary gummed flaps
"
Because the envelopes pass through heated rollers, the gummed
area on the flaps may seal. Using envelopes with emulsion-based
glue avoids this problem.
„ Approved for laser printing
„ Dry
DO NOT use envelopes that have
„ Sticky flaps
„ Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for seal-
ing
„ Transparent windows
„ Too rough of a surface
„ Material that will melt, vaporize, offset, discolor, or emit dangerous fumes
„ Been presealed
Labels
A sheet of labels consists of a face sheet (the printing surface), adhesive, and
a carrier sheet:
„ The face sheet must follow the plain paper specification.
„ The face sheet surface must cover the entire carrier sheet, and no adhe-
sive should come through on the surface.
You can print continuously with label sheets. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
Try printing your data on a sheet of plain paper first to check placement.
Check your application documentation for more information on printing labels.
Capacity Tray 1 Up to 100 label sheets, depending on their
thickness
Tray 2/3/4 Up to 290 label sheets, depending on their
thickness.
Orientation Face up
Driver
Media Type
Label
Duplexing Not supported