Konica Minolta bizhub 40P - Manual (Page 57)

Configuration Menu Overview 47
DUPLEX
Settings
OFF /LONG EDGE/SHORT EDGE
If LONG EDGE is selected, the pages will be printed on both sides
of the paper for long-edge binding.
If SHORT EDGE is selected, the pages will be printed on both
sides of the paper for short-edge binding.
The setting specified in the printer driver will override this menu
setting.
COPIES
Settings
1 -9999
Specify the number of copies to be printed.
The setting specified in the printer driver will override this menu
setting.
COLLATE
Settings
ON/OFF
If ON is selected, all pages of the document are printed before the
next copy is printed.
If OFF is selected, all copies of the document are not printed
separately.
The setting specified in the printer driver will override this menu
setting.
"
This menu item appears only if an optional hard disk kit or a
CompactFlash card of 1 GB or more is installed.
FIN-
ISHING
Settings
SUB TRAY/MAIN TRAY/OFFSET
When SUB TRAY is selected, the paper is fed to the sub output
tray.
When MAIN TRAY is selected, the paper is fed to the main out-
put tray.
When OFFSET is selected, the paper is fed to the sub output tray
with each copy slightly shifted.
The setting specified in the printer driver will override this menu
setting.
"
The paper size available for SUB TRAY or OFFSET is as
follows:
Width:
89 to 216 mm ( 3.5 to 8.5 inches )
Length: 140 to 356 mm ( 5.5 to 14.0 inches )
"
OFFSET can be set only when COLLATE is ON .