Konica Minolta bizhub 40P - Manual (Page 204)

Dual In-Line Memory Module (DIMM) 194
5
Remove the panel.
6
Insert the DIMM at an angle
(about 45°) into the connector,
making sure that the notch on
the unit aligns with the tab on
connector, and then press down
carefully until it clicks into place.
"
Be sure to handle the
DIMM by the edges only.
"
You will hear a click when
the DIMM is properly
placed.
7
Reinstall the panel and tighten
the two screws.
8
Attach the right side cover.
9
Reconnect all interface cables.
10
Reconnect the power cord, and
turn on the printer.