Konica Minolta Printgroove - Manual (Page 12)

Printgroove ::Admin
8 User’s Reference Guide Rev. 1.4
3.3.3.1 Control > Queue to SG Communication
In order for Queue to work with the other modules, i.e., receive jobs from SG , it must be registered
to the Printgroove system and the User Accounts must be synchronized. Both of these
communications factors should normally occur at system startup. The password is set by Queue
and only needs to be entered into the password field if it has been changed since the last session.
3.3.3.1.1 Queue Registered to Printgroove System
The Register/Unregister button initiates communications with the Queue server, making it
available to the rest of the Printgroove modules. If the Queue server had previously been
successfully registered, the button will read Unregister, and clicking this button will cease all
communication with the server. This means that any jobs being sent to, or expected from,
Queue
will stop processing.
3.3.3.1.2 Queue Users Synchronized with SG Users
When Queue is initiated as a Printgroove module, the users and passwords in Queue will
populate the user table for Serve and Guide . The users will be inactive and will have no
permissions or Roles set, but the S/G Application Administrator can define the appropriate
permissions and activate the necessary users.
As mentioned earlier, this synchronization should occur at startup. If the
Queue password changes
or new users have been added, click on the Account Synchronization button to re-synchronize
the
Printgroove modules. If successful, the message shown in the green bar below will display.
Please note that if a user in Queue has the same name and password as a user in SG, the Queue
username and password will overwrite the SG username and password during synchronization!