Konica Minolta BIZHUB C253 - Manual (Page 23)

C253/C203 2-8
Administrator Operations 2
6
Click the [OK].
? What happens if a wrong Administrator Password is entered?
% If a wrong Administrator Password has been entered, the machine gives a message that tells that
authentication has not been successful. In this case, click [OK] and enter the correct Administrator
Password in the "Password" box.
% If the Enhanced Security Mode is set to [ON], entry of a wrong password is counted as unauthorized
access. If a wrong Administrator Password is entered a predetermined number of times (once to
three times) set by the Administrator of the machine or more, a message appears saying that the
machine accepts no more Administrator Passwords because of unauthorized access for any sub-
sequent entry of the Administrator Password. The machine is then set into an access lock state. To
cancel the access lock state, settings must be made by the Service Engineer; or, turn off, and then
turn on, the main power switch of the machine. If the main power switch is turned off and on, the
access lock state is canceled after the lapse of time set for [Release Time Settings]. When the main
power switch is turned off, then on again, wait at least 10 seconds to turn it on after turning it off. If
there is no wait period between turning the main power switch off, then on again, the machine may
not function properly.
Here is the sequence, through which the main power switch and sub power switch are turned on
and off:
Turn off the sub power switch
→ Turn off the main power switch → Turn on the main power switch
→ Turn on the sub power switch
? What if you fail to log on to the Admin Mode?
% If you have already logged on to the Admin Mode from the control panel or using PageScope Web
Connection, the machine displays a message that tells that another administrator has previously
logged on and rejects any attempt to log on to the Admin Mode using the PageScope Web
Connection. Click [OK] and wait for some while before attempting to access the Admin Mode once
again.
% If [Export to the device] operation is being executed using the PageScope Data Administrator, the
machine displays a message that tells you cannot log on to the mode because of the remote
operation being performed and rejects any attempts to the Admin Mode via the PageScope Web
Connection. Click [OK] and wait for some while before attempting to access the Admin Mode once
again.
? Is it possible to gain access to the Admin Mode while a job is being executed?
% If an attempt is made to log on to the Admin Mode while a job is being executed, the machine gives
a message that tells that it is now impossible to log on to the Admin Mode. Click [OK] and try logging
on to the Admin Mode after the execution of the job is completed.
7
Click the [Logout].
8
Click the [OK].
This allows you to log off from the Admin Mode.
2
Note
If you have logged on to the Admin Mode using the PageScope Web Connection and if you close the
web browser without clicking [Logout], the touch panel of the machine remains locked for 70 sec.