Konica Minolta BIZHUB C253 - Manual (Page 119)

C253/C203 3-4
User Operations 3
5
Enter the 8-to-64-digit User Password from the keyboard or keypad.
– Press the [C] key to clear all characters.
– Touch [Delete] to delete the last character entered.
– Touch [Shift] to show the upper case/symbol screen.
– Touch [Cancel] to go back to the screen shown in step 4.
6
Touch [OK].
7
Press [Access] or touch [Login].
– Go to step 15 if User Authentication only has been set, or "Synchronize" has been set for
Synchronize User Authentication & Account Track.
? What if a wrong User Name or User Password is entered?
% If a wrong User Name is entered, a message appears that tells that authentication has not been suc-
cessful. The machine then prohibits entry for User Authentication for 5 sec. and then causes the
screen of step 1 to reappear. Perform User Authentication once again.
% If there is a mismatch of User Password relative to the registered User Name, a message appears
that tells that authentication has not been successful. The machine then prohibits entry of User
Name and User Password for 5 sec. and then causes the screen of step 4 to reappear. Enter the
correct User Password.
% If the Enhanced Security Mode is set to [ON], the entry of a wrong User Password is counted as
unauthorized access. If a wrong User Password for the corresponding User Name entered is en-
tered a predetermined number of times (once to three times) set by the Administrator of the machine
or more, a message appears that tells that authentication has not been successful for any subse-
quent operation for authentication. The machine is then set into an access lock state, rejecting any
more logon attempts. To cancel the access lock state, the Administrator of the machine must per-
form the Release Setting. Contact the Administrator of the machine.
8
Touch [Account Name].