Konica Minolta MS7000 MKII - Manual (Page 67)

3 Scanner
3-41
3.22 Using the Cycle Print Mode
This function automatically scans the next image following a preset period
of time. Images are manually loaded onto the Carrier Glass in between
cycles.
This is a system setting that must be entered by an authorized Technical
Representative.
If you want to use the Cycle Print Mode, ask your Tech. Rep. to make the
necessary system setting. Then you can perform the following operations.
Specifying the interval between scanning operations
1 Press the "10" key to change
the value to "A". This
enables the Cycle Print
Mode.
2 Press the "1" key to change
values.
Each value corresponds to
an interval between
scanning operations as
shown below.
3 Press the Memory Input key
to store the currently
selected interval setting of
the Cycle Print Mode into the
memory.
10 1 C
10 1 C
Memory
Input Key
Value 1 2 3 4 5 6 7 8 9 0
Period (sec.) 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0
0816773201.book 41 ページ ２００４年６月２４日 木曜日 午後６時１４分