beautypg.com

Konica Minolta BIZHUB C652DS User Manual

Page 33

background image

bizhub C652/C652DS/C552/C552DS/C452

3-12

3.2

Configuring the basic settings

3

Staple/Punch

Staple:
Copies can be bound with a staple in the corner or with two staples.
Punch:
Copies can be fed out hole-punched.
The number of punched holes varies depending on the country (area)
where this machine is used. For details, contact your service representa-
tive.

Staple/Punch

Position Setting

Select the desired staple or hole-punch position.

[Auto]:
The staple or hole-punch position is automat-
ically set either at the top or at the left.
A staple or punch position along the long side
of the paper is selected if the original length is
11-11/16 in (297 mm) or less.
A staple or punch position along the short
side of the paper is selected if the original
length exceeds 11-11/16 in (297 mm).

If [Auto] is selected for the staple or hole-
punch position, load the original with the top
toward the back of the machine.

If desired, press [Original Direction], and then
specify the direction in which the original is
loaded.

Fold/Bind

Half-Fold

Select this setting to fold copies at the center in
half before feeding them out.

Center Staple & Fold

Select this setting to staple copies at the center
before feeding them out.

Tri-Fold

Select this setting to fold copies in three before
feeding them out.

Settings

1

1

This manual is related to the following products: