3 troubleshooting, Troubleshooting – Konica Minolta AU-211P User Manual
Page 64
Appendix
5
AU-211P
63
5.3
Troubleshooting
If an error occurs during running, refer to the following.
You will not be able to use this system if you format the HDD after changing
the encryption word or the setting of "Encryption Priority" or "Overwrite
Priority" to temporarily overwrite HDD data. In that case, contact your service
representative.
If any of the above errors recur after taking the specified action, or if other
errors occur, contact your service representative.
Status
Point to be checked
Action
Failed to
login.
Did you enter the correct PIN
code?
Check the PIN code, and enter the
correct one.
Cannot login.
Is the PKI card locked?
If the number of authentication
failures reaches a specific limit, the
PKI card will be locked to prevent
the authentication. For details on
how to unlock the PKI card, contact
the PKI card administrator.
Scanning
does not
start.
Did you restart the MFP after
connecting this unit to the
MFP?
Turn the MFP Main Power off,
disconnect the USB cable from
either the MFP or this unit once,
and connect it again. Wait at least
10 seconds, and turn the MFP Main
Power on.