Konica Minolta bizhub C10X - Manual (Page 126)

Network Connection 116
Setting the Address Manually
You may also manually change the printer’s IP address, subnet mask, and
gateway by using the following instructions. (See chapter 5, “Understanding
the Network Configuration Menus,” for more information.)
"
When the IP address is changed, add a new port or reinstall the
printer driver.
CAUTION
You should always notify your network’s administrator before changing
the printer’s IP address.
1
Turn on your PC and printer.
2
After the machine’s message window is initialized, set the IP address.
Press this
key . . . (until) the message window displays . . .
Main screen
MACHINE SETTING?
OK=SEL / or 1-9
NETWORK SETTING?
OK=SEL or 1-4
1 IP ADDRESS?
OK=SEL
*AUTO SPECIFY
<,> & SEL
AUTO *SPECIFY
<,> & SEL
ADDR=0 .0 .0 .0
OK=SEL
Use the keypad to input each number.
A single digit number, such as “1”, cannot be input as “001”. Align the num-
ber on the left and input “1” as “1 _ _”. Use the * and ) keys to move
between triplets.
The Cancel/C key can also be used for deleting. To cancel IP Address
menu, hold down the Cancel/C key for more than one second, and then
press the Cancel/C key again after all settings have been cleared.