Konica Minolta IC-308 - Manual (Page 39)

4-1
bizhub PRESS C1100/C1085
4
4
Basic Operations
4.1 Loading Paper
Loading paper into the Paper Feeder Unit PF-708
The following describes how to load paper into an optional Paper Feeder Unit PF-708. The same paper loading
procedure is used for Paper Feeder Units PF-707 and Paper Feeder Units PF-708. The same paper loading
procedure is used for each tray.
A
Pull out the tray to load paper into.
NOTICE
NOTICE
Trays can be pulled out only when this machine is turned on. Before
pulling out the target tray, check that the sub power switch is turned
on.
In order to prevent the machine from falling down, only one tray can
be pulled out at a time.
B
Turn the side guide lock knobs (2 pieces)
counterclockwise to loosen them.
C
While pressing the side guide lock release lever
(
), slide the side guide plates to any positions
( ).
Determine their locations based on the size indicator of the
bottom plate of the tray.
NOTICE
NOTICE
To slide the side guide plates, be sure to hold both side guide
plates together. If you move it by holding only either of the side guide
plate, the side guide plate that is held may become displaced.
D
While pressing the rear guide lock release lever,
slide the rear guide plate to any positions.
Determine their locations based on the size indicator of the
bottom plate of the tray.
E
To fix the side guide plates at the correct locations, load an appropriate amount of
paper into the tray while aligning it to the left-hand side of the tray.
NOTICE
NOTICE
Load paper with the print side facing up.