Konica Minolta bizhub C252P - Manual (Page 23)

2 Administrator Operations
2-6 C252P
Ad
minist
ra
to
r Op
er
at
ions
Chapter 2
? What is the Administrator Password used for accessing the Admin.
Setting mode via the PageScope Web Connection?
% When accessing the Admin. Setting mode using the PageScope
Web Connection, enter the same Administrator Password as that
for the machine.
7
Click the [OK].
? What happens if a wrong Administrator Password is entered?
% If a wrong Administrator Password has been entered, the machine
gives a message that tells that authentication has not been suc-
cessful. In this case, click [OK] and enter the correct Administrator
Password in the “Administrator Password” box.
% If the EnhancedSecurity mode is set to “ON,” entry of a wrong
password is counted as unauthorized access. If a wrong Adminis-
trator Password is entered a predetermined number of times (once
to three times) set by the Administrator of the machine or more, a
message appears saying that the machine accepts no more Admin-
istrator Passwords because of unauthorized access for any subse-
quent entry of the Administrator Password. The machine is then set
into an access lock state. To cancel the access lock state, turn off,
and then turn on, the main power switch of the machine. When the
main power switch is turned off, then on again, wait at least 10 sec-
onds to turn it on after turning it off. If there is no wait period be-
tween turning the main power switch off, then on again, the
machine may not function properly.
? What if you fail to log on to the Admin. Setting mode?
% If you have already logged on to the Admin. Setting mode from the
control panel or using PageScope Web Connection, the machine
displays a message that tells that another administrator has previ-
ously logged on and rejects any attempt to log on to the Admin.
Setting mode using the PageScope Web Connection. Click [OK]
and wait for some while before attempting to access the Admin.
Setting mode once again.
% If [Export to the device] operation is being executed using the Pag-
eScope Data Administrator, the machine displays a message that
tells you cannot log on to the mode because of the remote opera-
tion being performed and rejects any attempts to the Admin. Set-
ting mode via the PageScope Web Connection. Click [OK] and wait
for some while before attempting to access the Admin. Setting
mode once again.
c252P_security_E.book 6 ページ ２００７年４月１０日 火曜日 午後７時４６分