Konica Minolta bizhub PRO C1060L - Manual (Page 81)

5-31
bizhub PRO C1060L
5
bizhub PRESS C1070/C1070P/C1060
K
Click [Start].
L
When a message appears, place the
FD-5BT on the white calibration plate,
then click [OK] while holding it down.
NOTICE
NOTICE
When the FD-5BT is placed on the plate, it does not
come into contact with the white calibration plate.
Securely press down. If these is a gap, the default
adjustment will fail.
M
When the message is displayed, click
[OK] to start the measurement.
N
Prepare the printed chart.
- Place five to 10 blank sheets of the same
color under the printed chart so that it will
not be affected by the color of the working
table.
- If a ruler is available, align it on the chart.
- To make the measurement, remove the
FD-5BT from the target mask.