Setting the address manually, Setting the address manually 187, Caution – Konica Minolta magicolor 7450 II User Manual
Page 207
Network Connection
187
Setting the Address Manually
You may also manually change the printer’s IP address, subnet mask, and
gateway by using the following instructions. (See chapter 6, “Understanding
the Ethernet Configuration Menus,” for more information.)
"
When manually setting the IP address, turn off DHCP and BOOTP
first. In addition, when the IP address is changed, add a new port or
reinstall the printer driver.
If the control panel is used to change the IP address, the DHCP set-
ting is automatically set to OFF.
CAUTION
You should always notify your network’s administrator before changing
the printer’s IP address.
1
Turn on your PC and printer.
2
When the printer’s message window displays
READY
, set the IP address.
Press this
key . . .
(until) the message window reads . . .
READY
PROOF/PRINT MENU
or if no optional hard disk is installed:
PRINT MENU
INTERFACE MENU
JOB TIMEOUT
ETHERNET
TCP/IP