Alliance Laundry Systems UW60P3 - Manual (Page 35)

Programming
33 F232090 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Erasing a Cycle in Memory
1. Insert the key into the program mode switch
(located on the left side of the control module)
and turn the key to the PROGRAM position. The
display will read “CYC00.”
2. Press the Erase Cycle key. The display will read
“ECYC00.”
3. Press the two-digit code for the cycle number that
is to be erased. The display will read “ECYC25”
if cycle 25 is chosen.
4. Press the Enter key. The display will read
“WAIT” while it is erasing the cycle. The display
will then return to “CYC00.” If there is no such
cycle number in memory, the display will read
“NCYC25.” To not erase a cycle, press the Clear
key before pressing the Enter key. The display
will return to “CYC.”
5. Return the program mode switch to the RUN
position and remove the key.
Step Programming
Programming a Fill without Spray
This process is used in temperature-controlled fill
steps where it is desirable to fill without spray and add
water through the sump only.
To program a fill without spray, program a cold, hot,
or warm fill to level as in a normal fill step; however,
instead of pressing the Enter key after selecting the
level, press the Auxiliary key. The computer will
display a lower case “c,” “h,” or “w,” instead of the
usual upper case “C,” “H,” or “W.” Press the Enter
key now and program the time in the usual manner.
Programming a Fill Temperature
The table on the next page lists the required
procedures to produce specific results. The table
shows that when HIGH water level is programmed,
the display indicator is “H.” When MEDIUM level is
programmed, the display indicator is “M.” When
LOW level is programmed, the display indicator is
“L.” When OVERFLOW is programmed, the display
indicator is “O.”
When the Warm key is pressed, the next key pressed
will be another temperature key (Hot, Cold, or
Warm) before selecting the level. Exceptions to this
will be when RINSE or FLUSH steps are used: they
require no level commands, and water is added
through the door spray nozzle only.
Each time the Warm key is pressed, one hot and one
cold water valve is turned on. The machine is equipped
with four water valves (two fill and two spray); thus
pressing the Warm key twice will turn on all four
valves and reduce fill times.
Use the following procedure to program a fill to a
specific temperature:
1. The computer must be in the PROGRAM mode,
and the cycle programming sequence must be
ready for the next step.
2. Press the Cold key. The display will read “C.”
(HOT or WARM may be programmed instead to
control inlet valves during the first three seconds
of the fill. After the first three seconds, the fill is
the same regardless of the prompt.)
3. Press the key representing the desired water level
(Low, Medium, High, or Over). If High is
pressed, for example, the display will read “CH.”