Alliance Laundry Systems UW60P3 - Manual (Page 29)

Programming
27 F232090 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
13. A natural next step in the cycle might be a warm
rinse.
a. Press the Warm key and then the Rinse key.
The display will read “WR0539.”
b. Press the Enter key. The display will read
“M---S.”
c. Now enter the rinse duration in minutes and
seconds. A spray rinse lasting 2 1/2 minutes is
an appropriate choice.
Press key 2. The display will read “2M-00S.”
Now press key 3 and key 0. The display will
read “2M-30S.”
14. Press the Enter key. The display will read
“0639,” indicating that the computer is ready for
step 6.
15. Step 6 in the cycle might be a warm fill to high
level for a dilution rinse.
NOTE: The Rinse key controls a spin-spray rinse.
However, a dilution rinse is executed the same as a
wash step without the addition of detergents.
a. Press the Warm key (key 3) twice to turn on
two hot and two cold water valves to reduce
fill time. The display will read “W-0639.”
Then press the High key (key 3). The display
will read “WH0639.”
b. Press the Enter key. The display will read
“M---S.”
c. Enter the desired time for the computer to
allow the machine to fill to high level. Five
minutes is acceptable. Press key 5. The
display will read “5M-00S.”
NOTE: If the machine does not fill in the amount of
time programmed, the “FILL” alarm will be
displayed.
16. Press the Enter key. The display will read
“0739.”
17. Add a sour for step 7:
a. Press the Supply key and key 3. The display
will read “S30739.”
b. Press the Enter key. The display will read
“M---S.”
c. Enter the length of time for the supply to be
activated. In this case, thirty seconds is
adequate.
Press key 0 for minutes; press key 3 and then
key 0 for seconds. The display will read “OM-
30S.”
18. Press the Enter key as always after programming
a time duration. The display will read “0839,”
indicating that the computer is ready for step 8.
19. For step 8, program the agitation action for the
dilution rinse.
a. Press the Wash key and key 1 to program an
action with normal reversing. The display will
read “W10839.”
b. Press the Enter key. The display will read
“M---S.”
c. Enter the time for the dilution rinse (three
minutes).
Press key 3. The display will read “3M-00S.”
20. Press the Enter key. The display will read
“0939,” indicating that the computer is ready for
step 9.
21. The dilution rinse water must be drained.
a. Press the Drain key. The display will read
“D10939.”
b. Press the Enter key. The display will read
“M---S.”
c. Enter the length of time the computer will
allow the machine to drain (one minute).
Press key 1. The display reads “1M-00S,”
indicating that a one-minute step has been
programmed.
22. Press the Enter key to move to step 10 of the
cycle.
23. An extract step should now be programmed.
a. Press the Medium Speed key. The display
will read “MS1039,” indicating a medium-
speed spin.
b. Press the Enter key. The display will read
“M---S.”
c. Enter the length of time for the medium-speed
spin (one minute).
Press key 1. The display will read “1M-00S.”