Alliance Laundry Systems UW60P3 - Manual (Page 22)

Operation
F232090 20 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Cycle Execution
To start the selected cycle, press the Start key. If the
selected cycle number is not in the computer memory,
the display will show “NCYC.” If this happens, select
another cycle. Otherwise, the display will now show
the first step. For example, if the display reads “HL0l,”
“HL” represents a hot fill to low level, and “01”
indicates that this is the first step of
the cycle.
As the cycle proceeds, the display will show the
function being executed, the step number, and the
cycle number selected. Pressing the Edit Cycle key
while the cycle is running will cause the display to
show the remaining cycle time in minutes. Pressing
this key again will return the display to normal.
To begin the cycle at any step other than the first step,
press the Advance key to advance through the cycle to
the desired starting point. (The Advance key is
enabled at the factory and can be disabled at the
laundry site.) Then press the Start key.
It is possible to skip to the next step in a cycle, with the
exception of a drain step: Drain steps must be allowed
time to complete.
When the display shows the step desired to begin the
cycle, press the Start key.
If the door is not locked, the display will indicate
“CLOSE” and “DOOR.” If this occurs, be sure the
door is closed and locked and press the Start key
again.
If the LED indicator lights for the computer outputs
indicate that one or more outputs are activated but the
washer-extractor is not functioning according to the
output or outputs indicated, contact a service
technician.
As water fills the washer-extractor, one or more of the
indicator lights located to the left of the keyboard will
come on and stay on until the required water level is
reached. LED dots located in the upper left corner of
the last three digits on the right of the display will
illuminate to indicate the water level(s) reached:
● When the indicator dot in the last digit on the
right is lit, the low water level has been reached.
● When the dot in the next-to-the-last digit is lit,
medium water level (optional) has been reached.
● When the dot over the third digit from the right
has been lit, high level has been reached.
The cycle will continue until its completion. Then the
display will read “DONE.”
Test Cycle
Cycle number 01 is a test cycle used to analyze
washer-extractor functions. See the Programming
section of this manual.
Step 01 in cycle number 01 is a cold fill to low level.
This step is designed to give not quite enough time to
complete a fill, causing the display to read “FILL.”
Press the Start key to continue the fill, and the test
cycle will proceed.
Step 02 in the test cycle is a drain step. Again, the time
allotted is shorter than it would be in a normal cycle.
The display will read “EMTY.” To proceed, press the
Start key.
The steps in the test cycle are relatively short with the
exception of steps 3 and 21. These can be shortened by
pressing the Advance key to go on to the next step.
The operator may skip to any next step in the cycle
with the exception of a drain step: Drain steps must be
allowed to complete. To skip forward in the test cycle,
press the Advance key.
NOTE: The Advance feature may be disabled. See
Prompting the WE-6 under System Programming
in the Programming section of this manual.