Vollrath M202B Water Cooled User Manual

Page 21

Owner’s Manual #513666 Rev.1

M202B Model Machines

Drive Belt Wear and Tension

Inspect the drive belts for wear. Check for wear marks
from the belts rubbing on the pulley. Use a Burroughs Belt
Tension Gauge to set the tension for the drive belt. Set
the belt tension to 40-50 lbs. If an adjustment is necessary,
loosen the four motor plate retaining nuts, adjust the belt
tension then retighten the four nuts.

3.13 EXTENDED STORAGE

Refer to the following steps for storage of the machine
over any long shutdown period:

Turn the Freezing Cylinder OFF-ON switch to the
OFF position.

Disconnect (unplug) from the electrical supply
source.

Clean thoroughly with a warm water detergent all
parts that are exposed to the mix. Rinse in clean
water and dry parts. Do not sanitize.

NOTE

Do not let the cleaning solution stand in the hopper
or in the machine barrel during the shutdown period.

Remove, disassemble and clean the faceplate,
fl ow control assembly and auger parts. Place the
auger blades and the front auger wear bushing in
a plastic bag with a moist paper towel to prevent
them from becoming brittle.

This manual is related to the following products:

M202B