Vollrath O231 Water Cooled - Manual (Page 25)

19
F. Machine Statistics (6 of 10)
The Machine Statistics screen 6 of 10 shows the total run
time for the compressor and counts the total cycles. There
is an option to reset the timer and the screen shows when
the last reset was done. The reset should be used if the
compressor is changed.
G. Machine Statistics (7 of 10)
The Machine Statistics screen 7 of 10 shows the total run
time for the drive motor and counts the total cycles. There
is an option to reset the timer and the screen shows when
the last reset was done. The reset should be used if the drive
motor is changed.
H. Machine Statistics (8 of 10)
The Machine Statistics screen 8 of 10 shows the total run
time for the pump and counts the total cycles. There is an
option to reset the timer and the screen shows when the
last reset was done. The reset should be used if the pump
is changed.
I. Machine Statistics (9 of 10)
The Machine Statistics screen 9 of 10 shows the amount
of time the pump hose has been in use and when the last
reposition was completed. There is also an option to reset
the hose timer.
NOTE
The hose timer must be reset each time the hose is
repositioned or replaced to keep an accurate record
of the hose service time.
J. Machine Statistics (10 of 10)
The Machine Statistics screen 10 of 10 shows when the
machine was last powered on. The screen also gives an
average power consumption per day.