Vollrath O231 Water Cooled - Manual (Page 21)

15
This menu contains settings for the CutIn and CutOut,
cycles in serve mode and auger cycle times. This screen
is available to the Technician level.
Cylinder can be changed by pressing the SEL button.
CutOut Consistency is a number that represents how
thick or thin the product in the freezing cylinder is. Incresing
the setting creates a thicker product. Decreasing the
setting makes a thinner product.
CutIn Temperature is the suction line temperature in the
cylinder when a freezing cycle will start.
Cycles Until Sleep is the number of freezing cycles before
the freezing cylinder goes into Sleep Mode.
Stir On is the amount of time that the auger rotates during
the stir cycle. Stir cycles occur in Serve Mode, Standby
Mode and Sleep 2 Mode.
Stir Off is the amount of time between stir cycles. Stir
cycles occur in Serve Mode, Standby Mode and Sleep 2
Mode.
C. Advanced Settings (1 of 2)
The Advanced Settings menu contains standby and sleep
mode adjustments and is available to the Technician level.
Press the right arrow to go to the second screen.
Cylinder can be changed by pressing the SEL button.
The Standby On Time setting determines the length of the
freezing cycle in Standby Mode.
The Standby Off Time setting determines the length
between freezing cycles in Standby Mode.
The Standby Time setting determines the total amount of
time in Standby Mode.
Sleep 1 Drive On is the amount of time that the auger
rotates during the stir cycle in Sleep 1 Mode.
Sleep 1 Drive Off is the amount of time between stir cycles
in Sleep 1 Mode.
D. Advanced Settings (2 of 2)
The Advanced Settings menu contains standby and sleep
mode adjustments and is available to the Technician level.
Press the left arrow to go to the first screen.
Sleep 2 CutIn is the temperature that a freezing cycle
starts in Sleep 2 Mode.
Sleep 2 CutOut is the temperature that a freezing cycle
stops in Sleep 2 Mode.
Default Off Time is the maximum time between freezing
cycles during Serve Mode.
E. Storage Settings (1 of 2)
This Storage Settings menu contains storage refrigeration
parameters and is available to the Technician level. Press
the right arrow to go to the second screen.
Storage CutIn is the temperature at which the storage
refrigeration cycle starts. This is how warm it will get before
starting a storage freezing cycle.
Storage CutOut is the temperature at which the storage
refrigeration cycle stops. This is how low the temperature
will get before ending the storage freezing cycle.
The Storage Offset value is added to the storage tempera-
ture reading to determine if storage refrigeration starts with
a freezing cycle. This setting helps prevent short cycling
and saves energy.
The Storage Off setting determines the time between
storage refrigeration cycles during a sensor failure.
The Storage On setting determines the length of a storage
refrigeration cycle during a sensor failure.