Vogels PFW 6851 - Manual (Page 7)

Installation Instructions Page 7
PFW 6851
Concrete Surface Installation
If concrete wedge anchors are not used (as described in these installation instructions) and you decide on other mounting
hardware, please follow the installation instructions as provided with that hardware.
THE FOLLOWING STEPS MUST BE PERFORMED BY TWO PEOPLE.
Level
Mark
Step 1. Determine the desired viewing location.
Step 2. Place the mount into position against the
wall and level the mount.
Step 3. Mark off four holes to be used for securing the
mount.
Step 4. Next, drill holes using a masonry bit (commercially
available) for your anchors.
Step 5. Insert a commercially available concrete anchor into
each hole.
Step 6. Use a hammer and lightly tap each anchor into place
so that only the threaded shaft of the concrete wedge
anchor is protruding from the wall.
Concrete Wedge Anchor
Drill Hammer Threaded Shaft
When determining viewing height, the center
of the TV should be at eye level while sitting in
an upright position. When using the flat panel
as room decoration, raise it to the point where
the bottom of the screen is at eye level while
sitting and the top is eye level when standing.