Vogels PFW 6851 - Manual (Page 11)

Installation Instructions Page 11
PFW 6851
Adapter Plate Installation (optional)
The adapter plates can be used with mounting patterns from 200mm x 200mm to 650mm x 840mm.
In the event that your flat panel has recessed or an uneven mounting surface, universal spacers may be stacked to achieve
proper spacing. Select the amount of universal spacer (s) that is closest in depth to keep your adapter plate as close to the flat
panel as possible. The universal spacer must be secured between the flat panel and the adapter plates.
Do NOT over-tighten the screws.
Step 1. Determine if your flat panel will need the
adapter plates.
Step 2. Locate the mounting points on the back of the
flat panel.
Step 3. Using a screwdriver, insert and tighten the
mounting hardware and adapter plates to the
back of the flat panel. Do not over-tighten the
screws.
Step 4. Place the universal mounting brackets over
the threaded mounting studs that are on the
adapter plate.
Step 5. Place one (1) 5/16” flat washer onto each
threaded mounting stud.
Step 6. Thread one (1) M8 nylon nut onto each
threaded mounting stud.
Step 7. Once the universal mounting brackets are level,
use a 1/2” socket and socket wrench to tighten
the M8 nylon nuts. Do not over-tighten the
screws.
Before tightening the nylon nut, be sure
that both universal mounting brackets are
level and aligned with each other. If they are
not aligned and level, the flat panel will not
sit properly when mounted to the PFW 6851.
Griplate
Mounting
Hardware
Flat Panel
Adapter Plate
Flat Washer
Nylon Nut
Universal Mounting
Bracket
Adapter Plate
Socket Wrench