Vogels PFW 6852 - Manual (Page 9)

PFW6852
Installation Instructions Visit the Vogel’s website at http://www.vogels.com Page 9
Installing the Swingout Arm (cont’d)
Step 2
Step 3
n n Set aside your Swingout Arm.
n o Use a power drill and concrete drill bit to drill holes at
the marks.
n p Insert a wedge anchor into each hole.
n q If necessary, use a hammer to lightly tap each wedge
anchor into place so that they are flush with the wall.
n n Move your Swingout Arm back into position.
n o Attach the wedge anchor nut and washer onto the
threaded shaft that is protruding from the wall.
n p Do not tighten any hardware until all wedge anchor
nuts and washers are in place.
Proceed to the “Mounting Hardware Selection” section.