Vogels PFW 6852 - Manual (Page 12)

PFW6852
Page 12 Visit the Vogel’s website at http://www.vogels.com Installation Instructions
Mounting Bracket Installation
Does your flat panel have a mount pattern for the
mount points greater than 506mm high x 876mm wide?
If No, proceed to the “Universal Bracket Installation”
section.
If Yes, proceed to the “Adapter Plate Installation
(Optional)” section.
Your PFW6852 Adapter Plates allow the PFW6852 mount to
accommodate very large flat panel mount patterns. Refer to
your flat panel User’s Guide for information regarding mount
point distances and patterns.
PFW6852 without Adapters: Width
Height
Minimum: 240mm x 120mm
Maximum: 506mm x 876mm
PFW6852 with Adapters: Width Height
Minimum: 200mm x 200mm
Maximum: 985mm x 667mm
Step 2
Universal Bracket Installation
n n Place the Universal Bracket Bar and the Universal
Brackets on a flat surface.
n o Slide the Universal Brackets onto the Universal
Bracket Bar with the set screws facing up.
Do not tighten the set screws that are located on
the back of each Universal Bracket.
Universal Bracket Bar
Universal Brackets
Step 1
n n Place the flat panel on a soft, flat surface, face-down.
n o Place nylon spacers over mount points, as
determined in the “Nylon Spacer Installation”
section.
n p Place the Universal Bracket assembly on the back
of the display, with the Universal Brackets resting
directly over the flat panel mount points.
n q Place a Griplate ™ over each mount point and secure
them using the mounting hardware determined in the
“Selecting the Mounting Hardware” section.