Vogels PFW 6852 - Manual (Page 6)

PFW6852
Page 6 Visit the Vogel’s website at http://www.vogels.com Installation Instructions
Installing the Swingout Arm
The following procedures instruct you on installing your PFW6852 Universal Swingout Arm on to wall studs or a
concrete wall. Please read these installation instructions once thoroughly before attempting to install your Vogel’s
product.
Please take a minute to familiarize yourself with the contents of the package and make sure you have all the parts and
tools you need to safely complete the installation.
In addition, some steps of this installation may require two people to prevent personal injury and/or damage to your flat
panel. Please obey all warnings in the following installation procedure, observe safe installation practices, and utilize
proper safety equipment at all times.
Proceed to the
“Mount Orientation” section.
Introduction
Your PFW6852 Universal Swingout Arm is designed to be installed with the Swingout Arm opening to either the
left-hand or right-hand side. Simply invert the PFW6852 Universal Swingout Arm and re-orient the Nose Piece.
Proceed to the
“Nose Piece Orientation” section.
Mount Orientation
Left-Hand Swingout Arm Orientation Right-Hand Swingout Arm Orientation
Nose Piece
Upright Orientation