Vogels PFW 6852 - Manual (Page 15)

PFW6852
Installation Instructions Visit the Vogel’s website at http://www.vogels.com Page 15
Attaching the Flat Panel to the Swingout Arm
Caution!
The following procedure requires two people.
Warning!
Until you install the M6 x 12mm screw and lock
washer, your flat panel can be easily dislodged,
causing severe personal injury and/or property
damage. Use extreme care if you push or pull on
the Swingout Arm.
n n Lift the flat panel/Universal Bracket assembly to the
Swingout Arm.
n o Slide the hood of the Universal Bracket Bar over the
top of the Nose Piece.
n p Slowly lower the flat panel/mounting bracket
assembly on to the Nose Piece.
n q Insert and tighten an M6 x 12mm screw and lock
washer to secure the flat panel/mounting bracket
assembly to the Swingout Arm.
WARNING!
Do not release the flat panel/mounting bracket
assembly until you are certain that hood of the
Universal Bracket Bar is firmly seated on the Nose
Piece.
Flat Panel Removed for Clarity
Insert and tighten two (2) M6 x 30mm locking screws
into the bottom of the Nose Piece.
Caution!
Do not overtighten the M6 x 30mm locking screws.
Proceed to the “Fine Tuning & Adjustments” section.
Step 2
Step 1