beautypg.com

300 lbs – Vogels PFW 6852 User Manual

Page 2

background image

PFW6852

Page 2

Visit the Vogel’s website at http://www.vogels.com

Installation Instructions

Contact Vogel’s with any questions:
+31 40 264 7400

Warning Statements

Weight Limit

Maximum Flat Panel Weight:

300 lbs.

THE WALL STRUCTURE MUST BE CAPABLE OF

SUPPORTING AT LEAST FOUR TIMES THE WEIGHT OF

THE FLAT PANEL. IF NOT, THE WALL STRUCTURE MUST

BE REINFORCED.

PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS MUST BE READ AND

COMPLETELY UNDERSTOOD. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION

FOR FUTURE REFERENCE.

PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN MUST BE FOLLOWED, AS OUTLINED

IN THESE INSTALLATION INSTRUCTIONS. FAILURE TO DO SO COULD RESULT IN PROPERTY DAMAGE, SERIOUS

PERSONAL INJURY, OR EVEN DEATH.

SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE ASSEMBLY OF THIS PRODUCT. USE

PROPER SAFETY EQUIPMENT AND TOOLS FOR THE ASSEMBLY PROCEDURE TO PREVENT PERSONAL INJURY.

VOGEL’S DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY VOGEL’S PRODUCT FOR

PURPOSES OTHER THAN THOSE FOR WHICH IT WAS DESIGNED OR DAMAGE CAUSED BY UNAUTHORIZED

ATTACHMENTS OR MODIFICATIONS, AND IS NOT RESPONSIBLE FOR ANY DAMAGES, CLAIMS, DEMANDS, SUITS,

ACTIONS OR CAUSES OF ACTION OF WHATEVER KIND RESULTING FROM, ARISING OUT OF OR IN ANY MANNER

RELATING TO ANY SUCH USE, ATTACHMENTS OR MODIFICATIONS.

At least two qualified people should perform the assembly procedure. Personal injury and/or property damage can result

from dropping or mishandling the flat panel.

If mounting to wall studs, make sure that the mounting screws are anchored into the center of the wall studs. Use of an

edge-to-edge stud finder is recommended.

It is recommended that a minimum of 1/2” drywall be used when mounting to wooden studs.

Be aware of the mounting environment. If drilling and/or cutting into the mounting surface, always make sure that there

are no electrical wires in wall. Cutting or drilling into an electrical line may cause serious personal injury.

Make sure there are no water or natural gas lines inside the wall where the mount is to be located. Cutting or drilling into a

water or gas line may cause severe property damage or personal injury.

This product is intended for indoor use only. Use of this product outdoors could lead to product failure and/or serious

personal injury.

Do not install near sources of high heat. Do not install on a structure that is prone to vibration, movement or chance of

impact.

Contents

Contents. ......................................................................................................................................................................... 2

Weight Limit. .................................................................................................................................................................... 2

Warning Statements. ....................................................................................................................................................... 2

Installation Tools. ............................................................................................................................................................. 3

Parts List.......................................................................................................................................................................... 3

Hardware. ........................................................................................................................................................................ 4

Features. ......................................................................................................................................................................... 5

Installing the Swingout Arm. ............................................................................................................................................ 6

Introduction. .............................................................................................................................................................. 6

Mount Orientation. .................................................................................................................................................... 6

Nose Piece Orientation. ............................................................................................................................................ 7

Wood Stud Installation. ............................................................................................................................................. 8

Concrete Installation. ................................................................................................................................................ 8

Mounting Hardware Selection. ...................................................................................................................................... 10

Selecting the Mounting Hardware. .......................................................................................................................... 10

Griplate™ Washer Installation. ................................................................................................................................11

Nylon Spacer Installation. ........................................................................................................................................11

Mounting Bracket Installation. ....................................................................................................................................... 12

Universal Bracket Installation. ................................................................................................................................. 12

Adapter Plate Installation (Optional). ...................................................................................................................... 13

Attaching the Flat Panel to the Swingout Arm. .............................................................................................................. 15

Fine Tuning & Adjustments. ........................................................................................................................................... 16

Tilt Positioning. ........................................................................................................................................................ 16

Cable Management. ................................................................................................................................................ 16

Technical Specifications. ............................................................................................................................................... 17

Warranty ........................................................................................................................................................................ 18

Disclaimer ...................................................................................................................................................................... 18