Vogels PFW 6852 User Manual
Page 16
PFW6852
Page 16
Visit the Vogel’s website at http://www.vogels.com
Installation Instructions
Before you can make tilt adjustments, you must loosen
both tension bolt nuts one-half turn.
Adjusting the Tilt Angle
n
n
Place one hand at the center top edge of the flat
panel.
n
o
Place the other hand on the center bottom edge of
the flat panel.
n
p
Using the upper hand, gently pull the top of the flat
panel towards you while the lower hand gently pushes
the bottom of the flat panel away from you.
Adjusting the Flat Panel to the Original Position
n
n
Place one hand at the center top edge of the flat
panel.
n
o
Place the other hand on the center bottom edge of
the flat panel.
n
p
Using the upper hand, gently push the top of the flat
panel towards the wall while the lower hand gently
pulls the bottom of the flat panel away from the wall.
After making any tilt adjustments, you must tighten the
tension bolt nuts one-half turn.
Fine Tuning & Adjustments
Tilt Positioning
Cable Management
You can easily route power and data cables through any
of the access points on the Swingout Arm. This not only
helps to prevent cables from being pinched, but helps
hide unsightly cable clutter.