Vogels PFW 6852 - Manual (Page 13)

PFW6852
Installation Instructions Visit the Vogel’s website at http://www.vogels.com Page 13
n n Center the Universal Bracket Bar.
n o Use the 5 /
32
″ Allen wrench to tighten the set screws
that are located on the back of each Universal
Bracket.
Do not overtighten the set screws.
Proceed to “Attaching the Flat Panel to the Swingout
Arm” section.
Step 3
Set Screws
Mounting Bracket Installation (cont’d)
Adapter Plate Installation (Optional)
Universal Bracket Bar
Universal Brackets
Attach the Adapter Plates to the flat panel using
Griplates ™ and the mounting hardware determined in
the “Selecting the Mounting Hardware” and “Nylon
Spacer Installation” sections.
Do not tighten the mounting hardware at this time.
Step 1
Step 2
Slide the Universal Brackets onto the Universal Bracket
Bar with the set screws facing up.
Caution!
Do not tighten the set screws that are located on
the back of each Universal Bracket.
If M10 x 30mm mounting screws are needed for
your installation, Griplate™ washers cannot be
used. Please use the four (4) 5 /
16
″ flat washers
(supplied) with the M10 x 30mm screws to attach
the adapter plates to the flat panel.