TRITTON X-55 Rhino H.O.T.A.S System Pro Flight - Manual (Page 16)

15
Making your first Profile
1. Either hover the mouse pointer over the Cell, or press the button you want to create a Profile for on the
controller. If you hover your mouse over the Button ‘A’ Cell, Button ‘A’ will light up on the 3D Joystick
image. Or just click Button ‘A’ on the stick and the correct Cell will light up.
2. When the correct Cell is lit, left-click in it and a
large flashing cursor will appear in the left side of
the Cell. You will also see a green tick, a red cross,
and a mouse icon on the right side of the Cell.
3. The Cell is now waiting for the keyboard
command. Using your keyboard, press the button on
the keyboard you would like Button ‘A’ on the stick
to activate. For this example we will use the ‘G’ key,
which usually activates landing gear. When you
press ‘G’ on the keyboard, a large white tile with the
letter ‘G’ should appear in the Cell, as shown here.
4. If this is the correct keyboard command, press
the green tick icon on the right side. If not, press
the red cross and redo the procedure to get the
keyboard command into the Cell again. After
pressing the green tick icon, the command name box
will appear, labeled as “Untitled” (left image, below).
Simply choose a name for the command and type
the name into this box. For this example, we chose
“Landing gear.” Press the enter key to complete
the Cell. Button ‘A’ = Landing gear, which is your
keyboard’s ‘G’ key (right image, below).