FMI ICST-01 - Manual (Page 6)

IN-ICST-01-07 6
Number 9 is the Dip Switch 6 (I/O6), the Blue wire.
Number 10 is the Dip Switch 7 (I/O7), the White wire.
4.1 P/N ICST-01/ OEM
J1 I/O Connector
PIN # FUNCTION
Pin 1 Ground the Lt Blue wire.
Pin 2 Ground the Lt Blue wire.
Pin 3 + 24 V (From input power supply) NC
Pin 4 + 24 V (From input power supply) NC
Pin 5 +5 V (Do not recommend using this, loads the voltage regulator) NC
Pin 6 +5 V (Do not recommend using this, loads the voltage regulator) NC
Pin 7 Input 1 (Used as start signal) Yellow wire.
Pin 8 I/O 1 = Program PIN1 the Black wire.
Pin 9 I/O 2 = Program PIN2 the Purple wire.
Pin 10 I/O 3 = Program PIN3 the Orange wire.
Pin 11 I/O 4 = Program PIN4 the Red wire.
Pin 12 I/O 5 = Program PIN5 the Gray wire.
Pin 13 I/O 6 = Program PIN6 the Blue wire.
Pin 14 I/O 7 = Program PIN7 the White wire.
J2 Sensor Connector (STD. Optical Sensor) P/N 110569
PIN # FUNCTION
Pin 1 +5 V cc the White wire.
Pin 2 Signal from sensor to board the Blue wire.
Pin 3 Ground the Green wire.
Pin 4 +5 V ir the Red wire.
Pin 5 Ground the Black wire.
J3 Motor Connector
PIN # FUNCTION
Pin 1 A Phase the Red wire. Note: See section 3 system
Pin 2 A bar Phase the Yellow wire. installation for motor wiring.
Pin 3 B Phase the Green wire.
Pin 4 B bar Phase the Blue wire.
J4 Programming Connector
For use with the programming cable only. See pages 12 and 13 for details.
J5 Relay output Connector
PIN # FUNCTION
Pin 1 + 24 Vdc the Red wire.
Pin 2 Control to ground for RELAY1 the Brown wire.
Pin 3 + 24 Vdc the Red wire.
Pin 4 Control to ground for RELAY2 the Orange wire.
Pin 5 Not used + 24 Vdc NC
Pin 6 Not implemented NC
Pin 7 Not used + 24 Vdc NC
Pin 8 Not implemented NC