Rs 232 parameters, Printout type, Printout ty – RADWAG Scales of WPT series User Manual
Page 33
13. RS 232 PARAMETERS
External devices connected to RS 232C have to be supplied from the
same mains and common electric shock protection. It prevents from
appearing a potential difference between zero leads of the two devices.
This notice does not apply to the devices that do not use zero leads.
Transmission parameters:
• Baud rate - 2400 – 38400 bit / s
• Data bits - 7,8
• Stop bits - 1,2
• Parity control - no, even, odd.
There are four ways of sending data via RS232 interface:
• Manually – after pressing
,
• Automatically – after stabilizing the indication over LO threshold
• Continuously – after it is activated in parameter or by a command
sent via RS232
• On external request - see - „List of scale - computer commands”.
The indication can be sent as:
• stable – the indication is sent after the scale stabilizes.
• any – the indication is sent immediately after pressing the
key,
this state is assign with in the printout.
13.1. Printout type
This parameter is to select the type of printout.
Procedure:
• Enter the submenu
- 33 -