Young Ultrasonic Anemometer Heated Model 85004 - Manual (Page 2)

Contents
SECTION DESCRIPTION PAGE
1.0 SPECIFICATIONS 1
2.0 INTRODUCTION 1
3.0 INITIAL CHECKOUT 1
4.0 INSTALLATION 2
4.1 Placement 2
4.2 Mounting and Alignment 2
4.3 Wiring and Power Requirements 2
5.0 OPERATION 2
5.1 With Wind Tracker Display 2
5.2 Voltage Outputs 2
5.3 Serial Output Formats and Protocols 2
5.4 Low Power Operation 4
6.0 SETTING SERIAL OUTPUTS AND OPERATING PARAMETERS
6.1 Setup using Young the 2DSETUP program 4
6.2 Setup using terminal Program 4
6.3 Command Overview 4
6.4 Command Details 5
7.0 EXAMPLE SETTINGS 6
7.1 Voltage Output, Minimum Power 6
7.2 RS232, Continuous ASCII, Minimum Power 7
7.3 RS232, Polled ASCII , Minimum Power 7
7.4 RS232, Polled ASCII Output 7
7.5 SDI-12 Continuous 7
7.6 SDI-12 Standby 7
8.0 HEATER OPERATION 7
9.0 WARRANTY 7
10.0 CE COMPLIANCE 7
APPENDIX
A WIRING CONNECTIONS 8
B SENSOR PHYSICAL 13
OPERATING INSTRUCTIONS
Model 85004 Ultrasonic Anemometer