Young Voltage & Current Interfaces 05631C - Manual

INSTRUCTION SHEET 05631C-90
REV: B051311
MODEL 05631C
WIND LINE DRIVER
SPECIFICATIONS
Wind Speed Input: YOUNG Wind Monitor series of sensors
AC sine wave, Frequency proportional
to wind speed. 3 pulses per revolution.
Input sensitivity nom. 40 mV p-p
Wind Direction Input: Analog voltage from azimuth
potentiometer. Regulated excitation
voltage is supplied from interface circuit
to potentiometer.
Wind Speed Output: 4 to 20 mA = 0-100 M/S
Wind Direction Output: 4 to 20 mA = 0 to 360°
Overall accuracy: ± 1% of full scale over temperature and
supply voltage range
Dimensions: 110 mm W x 75 mm H x 56 mm D
(4.3 in W x 2.9 in H x 2.2 in D)
Mounting: U-bolt for vertical pipe
25-50mm (1-2 in) Diameter
Power Requirement: 12-30 VDC
Temperature Range: -50 to 50°C (-58 to 122°F)
INTRODUCTION
The Wind Line Driver converts raw signals from the wind sensors to
proportional 4 to 20 mA current loop values. The Line Driver acts like
a variable resistance that draws 4 - 20 mA when powered with 12 to
30 VDC. Although it has only one PC board, the Line Driver contains
two completely independent circuits - one for wind speed and the
other for wind direction. See wiring diagram below.
IMPORTANT!
The Wind Line Driver provides a calibrated current signal
for wind speed and wind direction. Externally connected
devices should be reviewed for compatibility and correct
signal scaling.
Repairs should be attempted only by qualified service personnel.
Declaration of Conformity
R. M. Young Company
2801 Aero Park Drive
Traverse City, MI 49686 USA
Model 05631C Wind Line Driver
The undersigned hereby declares on behalf of R. M.
Young Company that the above-referenced product, to
which this declaration relates, is in conformity with the
provisions of:
Council Directive 2004/108/EC (December 15, 2004)
on Electromagnetic Compatibility
David Poinsett
R&D Manager
WARRANTY
This product is warranted to be free of defects in materials and
construction for a period of 12 months from date of initial purchase.
Liability is limited to repair or replacement of defective item. A copy
of the warranty policy may be obtained from R. M. Young Company.
CE COMPLIANCE
This product has been tested and shown to comply with European
CE requirements for the EMC Directive. Please note that shielded
cable must be used.
CALIBRATION FORMULAS
WIND SPEED vs mA OUTPUT
m/s = ( 6.250 x mA)-25
knots = (12.149 x mA)-48.6
mph = (13.980 x mA)-56
km/h = (22.500 x mA)-90
WIND DIRECTION vs mA OUTPUT
DEGREES = (22.5 x mA)-90
R. M. YOUNG COMPANY 2801 Aero Park Drive , Traverse City, Michigan 49686 U.S.A.
TEL (231) 946-3980 FAX (231) 946-4772 E-mail: [email protected]