beautypg.com

Young Voltage & Current Interfaces 05608C User Manual

Young Sensors

background image

INSTRUCTION SHEET 05608C-90

REV: A010313

MODEL 05608C

WIND SENSOR INTERFACE

0-5 VDC OUTPUT

R. M. YOUNG COMPANY

2801 Aero Park Drive, Traverse City, Michigan 49686 USA

TEL: 231-946-3980 FAX: 231-946-4772

INTRODUCTION

The Wind Sensor Interface provides calibrated analog DC voltage

signals for wind speed and wind direction. The unit consists of a

circuit board assembly in a weather resistant junction box. All cable

connections are made in the junction box. See wiring diagram below.

IMPORTANT!

The Wind Sensor Interface provides a calibrated voltage

output signal for wind speed and wind direction. Externally

connected devices should be reviewed for compatibility and

correct signal scaling.

Repairs should be attempted only by qualified service personnel.

WARRANTY

This product is warranted to be free of defects in materials and

construction for a period of 12 months from date of initial purchase.

Liability is limited to repair or replacement of defective item. A copy

of the warranty policy may be obtained from R. M. Young Company.

CE COMPLIANCE

This product has been tested and shown to comply with European

CE requirements for the EMC Directive. Please note that shielded

cable must be used.

Declaration of Conformity

R. M. Young Company

2801 Aero Park Drive

Traverse City, MI 49686 USA

Model 05608C Wind Sensor Interface conforms to the provisions of

Council Directive 2004/108/EC (December 15, 2004) on Electromagnetic

Compatibility

SPECIFICATIONS

Sensor Type:

Wind Monitor-HD (Model 05108)

NOTE: use with other models will result in

wind speed errors.

Wind Speed Input:

AC sine wave, Frequency proportional to

wind speed. 3 pulses per revolution. Input

sensitivity nom. 40 mV p-p

Wind Direction Input:

Analog voltage from azimuth potentiometer.

Regulated excitation voltage (nom

5.0vdc) is supplied from interface circuit to

potentiometer.

Wind Speed Output:

0 to 5.00 VDC = 0-100 M/S

Circuit time constant 0.2 second

Wind Direction Output: 0 to 5.00 VDC = 0 to 360°

Overall accuracy:

± 1% of full scale over temperature and

supply voltage range

Dimensions:

110 mm W x 75 mm H x 56 mm D

(4.3 in W x 2.9 in H x 2.2 in D)

Mounting:

U-bolt for vertical pipe

25-50mm (1-2 in) Diameter

Power Requirement:

8-24 VDC (5 mA @ 12 VDC)

Temperature Range:

-50 to 50°C (-58 to 122°F)