WIKA A2G-85 User Manual

Page 9

WIKA operating instructions air2guide model A2G-85

5. Transport, packaging and storage

5.1 Transport

Check the CO

sensor for any damage that may have been caused

during transportation. Obvious damage must be reported immediately.
5.2 Packaging

Do not remove packaging until just before mounting.

Keep the packaging as it will provide optimum protection during trans-

port (e.g. change in installation site, sending for repair).
5.3 Storage
Permissible conditions at the place of storage:

Storage temperature: -30 ... +80 °C

Protect the CO

sensor from humidity and dust.

6. Commissioning, operation

Installation and mechanical connection
The instruments are supplied in an operational status. The instrument

is already equipped with a 1.5 m long connection cable and there is no

need to open it. If an opening of the cover becomes necessary, make

sure that the case is hermetically sealed again afterwards.

The mounting to the ventilation duct is

made by means of the flange included

(mounting screws are not included in the

delivery).

40339564.02 07/2012 GB/D/F/E/I

5. Transport, packaging ... / 6. Commissioning, operation

Air velocity max. 10 m/s

Mounting flange