WIKA CEP1000 - Manual (Page 22)

22 WIKA operating instructions, model CEP1000
11570351.02 10/2010 GB/D/F/E/I
GB
8. Faults / 9. Return and disposal
8. Faults
Indication Type of fault Measures
Battery is low, functioning is only
guaranteed for a short period of time
Insert new batteries
OL
-OL
Reading is significantly above or
below the measuring range
Test: if the measurement parameter
is within the approved measuring
range of the instrument?
No display or
undefinable
characters, the
instrument does
not respond to
key press
Battery is dead. Insert new batteries
System error Turn off the CEP1000, wait for a
short period of time, switch on again
The CEP1000 is defective Send in for repair
CAUTION!
If faults cannot be eliminated by means of the measures listed above,
the instrument must be shut down immediately, and it must be ensured
that pressure and/or signal are no longer present, and it must be
prevented from being inadvertently put back into service.
In this case, contact the manufacturer.
If a return is needed, please follow the instructions given in chapter
"9.1 Return".
9. Return and disposal
WARNING!
Residual media in dismounted loop calibrator can result in a risk to
persons, the environment and equipment. Take sufficient precautionary
measures.
9.1 Return
WARNING!
Strictly observe when shipping the instrument:
All instruments delivered to WIKA must be free from any kind of hazard-
ous substances (acids, bases, solutions, etc.).