WIKA MHC-1 - Manual (Page 6)

6 WIKA operating instructions pressure transmitter, model MHC-1
14035467.01 08/2012 GB/D/F/E
GB
2. Safety
2. Safety
WARNING!
Before installation, commissioning and operation, ensure that the appropriate pressure
transmitter has been selected in terms of measuring range, design and specific measuring
conditions.
Non-observance can result in serious injury and/or damage to the equipment.
WARNING!
■ Open the connections only after the system has been depressurised.
■ Prior to opening the pressure transmitter, disconnect it from the power supply.
■ Always operate the pressure transmitter within the overpressure limit.
■ Observe the working conditions in accordance with chapter 3 "Specifications".
■ For the application of the pressure transmitter in connection with aggressive/corrosive
media and for avoiding mechanical damages, see chapter 3 "Specifications"
Further important safety instructions can be found in the individual chapters of these
operating instructions.
2.1 Intended use
The pressure transmitter is used to convert pressure into an electrical signal.
The pressure transmitter has been designed and built solely for the intended use described here and
may only be used accordingly.
The technical specifications contained in these operating instructions must be observed. Improper
handling or operation of the pressure transmitter outside of its technical specifications requires the
instrument to be taken out of service immediately and inspected by an authorised WIKA service
engineer.
The manufacturer shall not be liable for claims of any type based on operation contrary to the intended
use.