Commissioning, operation – WIKA MHC-1 User Manual

Page 18

WIKA operating instructions pressure transmitter, model MHC-1

14035467.01 08/2012 GB/D/F/E

6. Commissioning, operation

6.3 Configuration of the pressure transmitter

Factory settings

■

Bit rate = 250 kbit/s

■

CANopen: Node-ID = 1

■

J1939: Source address = 128

For further information on J1939 see "Additional instructions MHC-1 J1939“

The "Additional instructions" are available for download at www.wika.com.

6.4 EasyCom software installation

System requirement:

■

Operating system Microsoft

Windows

2000, XP, Vista or Windows

■

WIKA software EasyCom CANopen/J1939 (EasyCom CANopen/J1939 are available for download at

www.wika.com).

Windows is a registered trademark of Microsoft Corporation in the United States and other countries.

Installation

■

Connect the CAN adapter (PEAK PCAN-USB) to the PC and the pressure transmitter.

■

Install driver (once).

■

Start the CAN software (EasyCom CANopen/J1939).

■

Make sure that the correct bit rate and node ID / address of the pressure transmitter is used.

For further information on the CAN interface see "Additional instructions"

The “Additional instructions” are available for download at www.wika.com.