Kramer Electronics TP-134 - Manual (Page 13)

10 TP-133/TP-134 - Adjusting RGB and Compensation on the TP-134
6 Adjusting RGB and Compensation on the
TP-134
The skew and equalization can be set either manually or automatically.
After connecting the TP-133/TP-134 to the power adapters (assuming that the
twisted pair link is working), the LINK and POWER LEDs on the front of the
TP-134 light green.
Note: During any setup, the process times-out after 10 seconds and the device
returns to normal operation.
6.1 Setting the Skew and Equalization Manually
The color and equalization can be set either with the live signal or using the built-
in pattern generator.
6.1.1 Setting the Skew and Equalization Manually (Using a Live
Signal)
To set the color and equalization using a live signal:
1. Press the COLOR button briefly.
The RED LED flashes red.
2. To change the red gain, press the + or – button to increase or decrease the
gain respectively.
3. To move to the green setting, press and hold the COLOR button for three
seconds.
The GREEN LED flashes green.
4. To change the green gain, press the + or – button to increase or decrease
the gain respectively.
5. To move to the blue setting, press and hold the COLOR button for three
seconds.
The BLUE LED flashes blue.