Kramer Electronics TP-134 - Manual (Page 14)

TP-133/TP-134 - Adjusting RGB and Compensation on the TP-134 11
11
6. To change the blue setting, press the + or – button to increase or decrease
the gain respectively.
7. To move to the equalization setting, press and hold the COLOR button for
three seconds.
The RED LED flashes red and the GREEN LED flashes green together.
8. To change the equalization, press the + or – button to increase or decrease
the blue gain respectively.
9. To return to normal operation, either wait 10 seconds for the time-out or
press and hold the COLOR button for three seconds.
The LINK and POWER LEDs light green.
6.1.2 Setting the Skew and Equalization Using the Built-in Pattern
Generator
To set the color and equalization using the built-in pattern generator:
1. Press and hold the COLOR button for three seconds.
The RED LED flashes red and the OSD pattern is displayed with a broad,
red, horizontal band across the bottom to indicate the current setting.
2. To change the red gain, press the + or – button to increase or decrease the
gain respectively.
The effect is seen in the red vertical bars shifting to the left or right.
3. To move to the green setting, press and hold the COLOR button for three
seconds.
The GREEN LED flashes green and the OSD pattern is displayed with a
broad, green, horizontal band across the bottom to indicate the current
setting.
4. To change the green gain, press the + or – button to increase or decrease
the gain respectively.
The effect is seen in the green vertical bars shifting to the left or right.
5. To move to the blue setting, press and hold the COLOR button for three
seconds.