Kramer Electronics PT-110 - Manual (Page 5)

Overview
3
3.3 PT-120 XGA Line Receiver
The Kramer Pico TOOLS PT-120 is an XGA line receiver that receives a
coded CAT 5 signal transmitted by either the WP-110 or the PT-110,
decodes it and converts it to an XGA output. In particular, the PT-120:
• Has an operating range of more than 300ft (more than 100m) using
standard CAT 5 cable and the WP-110 or the PT-110
• Includes EQ. and level controls
• Has the power connect feature
• Is 12V DC fed
3.4 TP-120 XGA Line Receiver
The Kramer TOOLS TP-120 is an XGA line receiver that receives a coded
CAT 5 signal transmitted by either the WP-110 or the PT-110, decodes it
and converts it to an XGA output. In particular, the TP-120:
• Has an operating range of more than 300ft (more than 100m) using
standard CAT 5 cable and the WP-110 or the PT-110
• Includes EQ. and level controls
• Has the power connect feature
• Is 12V DC fed
3.5 About the Power Connect™ Feature
The Power Connect feature applies as long as the cable can carry power.
This feature is available when using STP cable and the distance does not
exceed 50m on standard CAT 5 cable. For longer distances, heavy gauge
cable should be used
1
. For units which are connected via RJ-45 connectors,
make sure that the shield of the STP cable is connected to the metal casing
of the connectors on both ends of the cable. For units which are connected
via terminal block connectors, the shield of the STP cable must be
connected to a ground terminal on the units at both ends (use the ground
terminal of the power supply connection if necessary).
For a CAT 5 cable exceeding a distance of 50m, separate power supplies
should be connected to the transmitter and to the receiver simultaneously.
1 CAT 5 cable is still suitable for the video/audio transmission, but not for feeding the power at these distances