Kramer Electronics RC-8iR - Manual (Page 2)

Contents
i
Contents
1 Introduction 1
2 Getting Started 1
3 Overview 2
4 Your Universal Room Controller 3
5 Installing the RC-8IR Universal Room Controller 5
5.1 Setting the Labels and Button Caps 6
5.2 Mounting the Device Housing 7
5.3 Mounting the RC-8IR Faceplate 7
6 Using the RC-8IR Universal Room Controller 8
6.1 Operating the RC-8IR 10
6.2 An Example of Operating the RC-8IR 11
6.3 Using the Macro Buttons 12
6.4 Locking the Front Panel 12
6.5 Turning the Light of the Backlit Buttons On and Off 12
6.6 Using the Internal Web Page 12
7 Flash Memory Upgrade 13
7.1 Downloading from the Internet 13
7.2 Connecting the PC to the RS-232 Port 14
7.3 Upgrading Firmware 14
7.4 Installing the Web Applet 15
8 Technical Specifications 15
Figures
Figure 1: RC-8IR Front Panel 3
Figure 2: RC-8IR Right Side Panel 4
Figure 3: RC-8IR Rear Panel 5
Figure 4: Button Cap Orientation 6
Figure 5: Placing the Button Cap 6
Figure 6: Mounting the Device Housing 7
Figure 7: Mounting the Faceplate 7
Figure 8: Example of a Typical RC-8IR Configuration 8
Figure 9: Example of a Typical RC-8IR Setup in the Lecture Auditorium 9
Figure 10: RC-8IR Labels Setup 10
Figure 11: RC-8IR Operation Example 11
Figure 12: Internal Web Page Front Panel 13
Figure 13: The KFR-Programmer Window 14