Kramer Electronics RC-8000 - Manual (Page 29)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operation
26
8 Operation
This section describes the hardware of the machine and the operation of its
front panel controls.
For instructions on using the Windows®-based Kramer control software,
refer to the separate user manual 1 , Kramer Control Software.
8.1 Technical Information
This section describes setup capacity, switching the power on, timeout and
the system settings.
8.1.1 Setup Capacity
From every switcher you can store up to 8 setups. From the PC you can store
up to 15 setups.
8.1.2 Switching the Power On
To switch the power on at all the switchers, do the following:
1. Verify, via the automatic self-test, that all switchers function correctly.
2. Check the firmware version number indicated by the two fast blinking
digits on the display 2 .
To switch the power on at the remote controller, do the following:
1. Attach the power adapter plug to the power socket on the remote
controller.
2. Verify, via the automatic self-test, that all switchers and the remote
controller function correctly.
3. The Comm. Error LED will illuminate to indicate a problem 3 , if at all,
with any switcher.
8.1.3 Timeout
By design, every push button operation is subject to a 30 second timeout.
Failure to fully execute an action within 30 seconds will necessitate restarting
that action whilst the LED display will show the previous state.
1 Included on the CD-ROM in .pdf format
2 For example, the digits 10 indicate version 1.0
3 For example, if a switcher is not connected, or its power is switched off